The newest OBDII Interface from HP Tuners allows you to connect your vehicle’s various supported control modules to the HP Tuners VCM Suite. The VCM Suite will allow you to read, diagnose, and clear trouble codes, while allowing you to pull the vehicle’s stock file and modify it. The possibilities are limitless with the ability to optimize your vehicle’s performance, fuel economy, torque response, and more.

What’s new with the MPVI3?

• Now comes standard with the Pro Feature set ( Pro Link cable sold separately)
• Faster standalone datalogging
• Improved storage (8 MB/s over the MPVI2+ 4 MB/s)
• High-resolution accelerometer

MPVI3 continues the legacy of its predecessor with features like Bluetooth 5.0, an M8 motorsports-grade screw-on connector, RGB LEDs, and USB-C connectivity.

Get equipped with the most inclusive scanning, logging, and calibration package in the industry. Connect > MPVI3 is an advanced OBDII interface tool, connecting your vehicle’s control modules to the VCM Suite software. Read > Run complete diagnostics, monitor vehicle performance, read from various vehicle control modules, and more in VCM Suite. Edit > Optimize your performance, fuel economy, or whatever your vehicle goals may be in VCM Editor with a multitude of defined parameters. Write > When you are ready, license and tune any vehicle currently supported by HP Tuners with the fastest read and write speeds available. Drive >>>

From dedicated race cars to tow rigs, off-road machines, next-level street cars, and fuel-efficient daily drivers, HP Tuners delivers the ultimate solution for builds and enthusiasts of any caliber.

Credits & Licensing

When modifying and flashing a vehicle, there is a required one time licensing fee. Check HERE to see what your vehicle will need for licensing. Universal Credits are the ONLY credits that the MPVI3 interfaces will take.

Need to view more data with your MPVI3 from a wideband sensor, boost gauge, or other additional sensors? Get equipped with the ProLink cable (sold separately), enabling users to wire in and record up to 2x analog signals (from a wideband sensor, map sensor, etc.) and 1x CAN bus signal simultaneously. Now standard with Pro Feature Set, MPVI3 is fully compatible with the PROLINK+ cable straight from the box.

*PROLINK+ is not required for MPVI3. The ProLink cable must be wired in for use.

This tuning service is ideal for the following Modifications,

Transmission tuning is also recommended.

Faster Shifts

Higher Shift Points

Torque Management Adjustments

Any questions please let us know.